![]() ![]() When the tire touches the rim, air will fill the tire and continue seating itself along the rim. While air is flowing into the tire, pull up aggressively on the sides of the tire to mate the inner edge of the tire back onto the rim. Place the needle back into the valve-stem and begin filling the tire with air. Place the needle back into the valve-stem and begin filling the tire with air Also, wipe the inner edge of the tire to clean any loose debris or dirt. Clean the inside edge of the rim with warm soapy water and a shop rag. Press the tire downward, away from the rim. Press the tire downward, away from the rim Once the seal breaks, the entire side of the tire will release from the rim. ![]() While holding the board in position, hit the board with the shop hammer to break the tire's bead loose from the rim. Place one end of the 2 by 4 board on the rubber part of the tire, right next to the steel rim's edge. Place one end of the 2 by 4 board on the rubber part of the tire Turn the tire so the leaking side of the rim and tire face up. Turn the tire so the leaking side of the rim and tire face up If a valve-stem removal tool is available, remove the valve-stem needle by unscrewing it from the stem. Release the air from the tire by pressing inward on the valve-stem. Release the air from the tire by pressing inward on the valve-stem Mark the leaking area of the tire with chalk. If one side of the tire shows no sign of a leak, turn the tire over and repeat the soapy water leak test. The area of the leak is identifiable by bubbles generated from leaking air. Fill the tire with air and spray soapy water around the outer edge of the rimįill the tire with air and spray soapy water around the outer edge of the rim where the tire meets it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |